d) Only use the machine during daylight or with sufficient
artificial light.
e) Always assume a stable stance with proper posture, espe-
cially when working on slopes.
f) Walk, do not run.
g) Do not touch any moving, dangerous parts before the
machine has been disconnected from the mains and the
moving parts have come to a stop.
h) Never use the machine if a cover or protective equipment
is damaged or without a cover or protective equipment.
i) Only switch the motor on if your hands and feet are out of
the reach of the cutting unit.
j) Make sure that the vents are kept free of debris.
k) Be cautious to prevent injuries to the hands and feet
caused by the cutting unit.
l) Keep the extension cord away from dangerous, moving
parts to prevent damage to the extension cord.
m) Only use the machine in the recommended position and
only on a solid, level surface.
n) Do not operate the machine on cobbled or gravel surfaces
where material that is projected could inflict injury.
o) Always disconnect the machine from the power supply
(that is, disconnect the plug from the mains, remove the
locking device or the removable battery),
1) when the machine is left unattended;
2) before removing a blockage;
3) before checking, cleaning or processing the machine;
4) after contact with debris;
5) when the machine starts to vibrate unusually.
To Next Page
Loading...
Need help?
General
