Maintenance and storage
a) The machine must be disconnected from the power supply
(that is, disconnect the plug from the mains, remove
the locking device or the removable battery) before
performing maintenance or cleaning.
b) Only the spare parts and accessories recommended by the
manufacturer are to be used.
c) Regularly check and maintain the machine. Only have the
machine repaired in an authorised workshop.
d) If the machine is not in use, store it out of the reach of children.
Recommendation
The machine should be operated with a residual current device
(RCD) with a release current of no more than 30 mA.
Connector cable
e) Only use connector cables that are not damaged. Do not oper-
ate the grass trimmer if the lines are damaged or worn out.
f) The connector cable must not be of any length (max. 50 m).
Otherwise the output of the motor will be reduced. The con-
nector cable must have a cross section of 3 × 1.5 mm.
g) Longer connector cables require a larger conductor
cross-section.
h) The insulation of connector cables for grass trimmers is
often damaged. Some of the causes of this are: cuts caused
from cutting into the line, crushing when the connector
cable is run under doors and windows, cracks due to the
ageing of the insulation, kinked areas due to improper
fastening or guidance of the machine’s connector cable.
i) The connector cables must be at least of type H05RN-F and
triple core. The type designation must be printed on the con-
nector cable. Only purchase connector cables with a label!
To Next Page
Loading...
Need help?
General
