EasyManua.ls Logo

ALDI N1F-GT-250/18-D - Charger Safety Rules

ALDI N1F-GT-250/18-D
37 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety Instructions
g) Be aware of your work environment. Baeries can explode in the presence of a source of igni-
on, such as a pilot light. To reduce the risk of serious personal injury, never use any cordless
product in the presence of open ame. An exploded baery can propel debris and chemicals. If
exposed, ush with water immediately.
h) Do not crush, drop or damage baery pack. Do not use a baery pack or charger that has
been dropped or received a sharp blow. A damaged baery is subject to explosion. Properly
dispose of a dropped or damaged baery immediately.
i) Proper charging temperature. For best results, baery pack should be charged in a locaon
where the temperature is between 41°F and 104°F (5°C to 40°C). Charging me will increase if
the baery is charged in lower or higher temperature than specied.
j) Pay aenon to baery leakage. Under extreme usage or temperature condions, baery
leakage may occur. If baery liquid comes in contact with your skin, wash immediately with soap
and water, then neutralize with lemon juice or vinegar. If liquid gets into your eyes, ush them
with clean water for at least 10 minutes and, seek immediate medical aenon. Following this
rule will reduce the risk of serious personal injury.
6. CHARGER SAFETY RULES
a) Do not place any object on top of charger or place the charger on a so surface that might
block the venlaon slots and result in excessive internal heat. Place the charger in a posion
away from any heat source. The charger is venlated through slots in the top and the boom of
the housing.
b) Do not mount charger on wall or permanently ax charger to any surface. The charger is
intended to be used on a at, stable surface (i.e., table top, bench top).
c) Do not operate charger with damaged cord or plug have those replaced immediately.
d) Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged
in any way. Take it to an authorized service center.
e) Do not disassemble charger. Take it to an authorized service center when service or repair is
required. Incorrect reassembly may result in a risk of electric shock, electrocuon or re.
f) Disconnect the charger from the outlet before aempng any cleaning. This will reduce the
risk of electric shock. Removing the baery pack will not reduce this risk.
g) NEVER aempt to connect two or more chargers together.
h) The charger is designed to operate on standard house hold electrical power (120 Volts). Do
not aempt to use it on any other voltage.
AFTER SALE SUPPORT
support@sumec-na.com
7
1855 399 9415
MODEL: N1F-GT-250/18-D PRODUCT CODE: 45239 04/2015
Cordless Trimmer · 18V Lithium-ion Battery

Related product manuals