ALDI N1F-GT-250/18-D - Operation; Switch ON and OFF

Operation
Operation
WARNING: Always use the correct voltage: the voltage of the power source must match with the
values on the nameplate of the tool.
Switch ON and OFF (Fig 9 & 10)
WARNING: Always use proper eye protecon that conforms to ANSI Z87.1 (CAN/CSA Z94.3) stan-
dards while operang this machine.
Inspect area to be trimmed and remove any wire, cord, or string-like objects which could become
entangled in the rotang line or spool. Be parcularly careful to avoid any wire which might be
bent outwardly into the path of the tool, such as barbs at the base of a chain link fence.
-To switch the trimmer on, push the lock-o buon and squeeze the switch trigger.
-With the unit on, grasp both handles and angle, slowly swinging the trimmer side to
side.
-To switch the trimmer o, squeeze the switch trigger again.
-Restarng the machine aer complete stop will feed the spool line automacally. Do
not bump unit on ground to feed the line.
Note: Trimming ps
Keep the trimmer lted toward the area being cut, this is the most ecient cung area.
The string trimmer cuts when moving the unit from le to right. This will avoid throwing debris
at the operator.
Use the p of the string to do the cung, do not force string head into uncut grass.
Wire and picket fences cause extra string wear, even breakage. Stone and brick walls, curbs and
wood may wear string rapidly.
Avoid trees and shrubs. Tree bark, wood moldings, siding and fence posts can easily be damaged
by the strings.
AFTER SALE SUPPORT
support@sumec-na.com
13
1855 399 9415
MODEL: N1F-GT-250/18-D PRODUCT CODE: 45239 04/2015
Fig.9 Fig.10
Cordless Trimmer · 18V Lithium-ion Battery