ALDI OC 500 - Product Operation; Cutter Bar Maintenance

Attention: Changing your desired cutting mode is only possible if the
blade head is located in starting position.
Changing the cutter bar
- After frequent use of the rotary cutter, the cutter bar
3
may wear out. In this
case you can rotate the cutter bar
3
.
- To do this, firstly move the blade head
5
back into the starting position.
- Loose the screw on the cutting head guide rail with a screwdriver to remove
the blade head or cutter bar.
- Then lift the guide rail
4
in the centre to release it from the catches. At the
gap in the centre of the base, you can lift and remove the cutter bar (Fig. 4).
- Rotate the cutter bar
3
either 90° through its own axis or 180° through the
transverse axis (Fig. 4).
- Reassemble the rotary cutter, firstly by inserting the rotated cutter bar
3
into
the gap underneath the blade head, which is in the starting position.
- After that, introduce the guide rail
4
into the catches on the opposite sides
and press it back into the guide track. After changing the blade head or cutter
bar please necessarily fasten the screw on the cutting head guide rail with a
screwdriver!
- You may now continue cutting.
Operation
10