First use
Checking the office cutter and product contents
NOTICE!
Risk of damage!
If you are not cautious when opening the packaging with a sharp
knife or other pointy object, you may quickly damage the office cutter.
- Therefore, be very careful when opening.
1. Take the office cutter out of the packaging.
2. Check whether the office cutter or the individual parts exhibit damage. If this
is the case, do not use the office cutter. Contact the manufacturer at the service
address specified on the warranty card.
3. Check to make sure that the delivery is complete (see fig. A, page 3).
Connecting, disconnecting and storing
Connecting the cutting units
- In order to connect the two cutting units, set the guillotine on a level base.
- Keep the rotary cutter vertical (at 90°) to the guillotine (Fig. 1, page 10) and
insert it into the connecting components a the guillotine.
- Fold the rotary cutter down to the left.
- The cutting units are now ready for use and safeguarded.
WARNING!
Risk of crushing!
- While the rotary cutter is being unfolded into its operating state,
there is a risk of crushing!
- Possible risk of crushing while connecting and unfolding the
cutting units for operation!
First use
7
To Next Page
Loading...