− Keep ties, scarves, loose clothing, and long necklaces or
bracelets well away from the feed slots.
− Keep the feed slots away from aerosols.
− Only hold the CD by the outer edge when inserting into the
feed slot. Make sure that your finger is not in the CD hole; this
can cause injury when the CD is drawn in.
− Set up the paper shredder in the vicinity of a properly installed
socket. The socket must be freely accessible.
− Remove regularly any shredded paper, credit card and CD
residue from the underside of the cutting unit using a suitable
tool (e.g. a brush).
− Always switch the paper shredder off and unplug the power
plug before emptying the waste bins.
− After pulling out the waste bins, sharp and pointed parts of the
cutting unit become touchable. Operate carefully.
− Lay the power cord so that it does not pose a tripping hazard.
− Only use the paper shredder when it is fully and correctly
assembled.
− Never disassemble the paper shredder for cleaning or storage.
NOTICE!
Risk of damage!
Improper handling of the paper shredder may result in damage to
the paper shredder.
− Do not operate the paper shredder for longer than 3minutes
without interruption. Allow it to cool down to room
temperature first before restarting operation.
− Do not drop paper clips or staples into the feed slots.
− Both cutting units will rotate when one is activated by the
respective detection sensor. Make sure that there are no objects
close to the feed slot which is not in use.
To Next Page
Loading...
Need help?
General
