Cleaning
WARNING!
Burn hazard!
The laminator will become hot during operation.
− Always let the laminator cool off completely before you clean
it.
NOTICE!
Risk of short circuit!
Water that has penetrated the housing may cause a short circuit.
− Never submerge the laminator in water.
− Make sure that no water penetrates the housing.
NOTICE!
Risk of damage!
Improper handling of the laminator may result in damage to the
laminator.
− Do not use any aggressive cleaners, brushes with metal or ny-
lon bristles, sharp or metallic cleaning utensils such as knives,
metal sponges and the like. They could damage the surfaces.
− Do not in any case place the laminator in the dishwasher.
It would be destroyed as a result.
1. Disconnect the mains plug before cleaning.
2. Let the laminator cool off completely.
3. Use a damp cloth to wipe off the laminator. Let all parts dry completely afterwards.
Cleaning the heating rollers
1. Switch the laminator on by moving the ON/OFF switch
4
to “ON” (―).
2. Once the ready indicator
1
turns red, fold a sheet of paper and insert it, folded-
edge first, into the laminating pouch infeed slot
2
.
3. Keep repeating this process until no more glue deposits cling to the paper.
4. Switch the laminator off by moving the ON/OFF switch to “OFF” (
To Next Page
Loading...
