Safety
9
− Never add water to the product’s vapour discharge opening or
vapour discharge channel. Wipe wet areas on the product with
a dry cloth.
− Do not put any metals, chemicals or cleaners in the water tank.
Otherwise, humidification won’t work properly.
− Never remove residual water from the steam pipe when the
product is switched on. This can destroy the sensor.
− Do not move the product around too much if there is a lot of
water in the water tank. Otherwise, water may leak and can
get into other parts of the product.
− Never immerse the product in water or use a steam cleaner to
clean it. Otherwise, the product could be damaged.
− Never place the product in a dishwasher. It would be
destroyed as a result.
− Stop using the product if any of the product’s plastic parts
show cracks or deformation. Only replace damaged parts with
corresponding original spare parts.
− Refer to the ‘Cleaning’ chapter.
To Next Page
Loading...