ALDI STIRLING STR-5F80L - Removing Inner Door Glass Panel

29
AFTER SALES SUPPORT
1300 886 649
info@tempo.org
AUS
MODEL: STR-5F80L PRODUCT CODE: 700805 04/2020
Other Useful Information (Cont.)
Removing the door’s inner glass panel for cleaning
IMPORTANT: Do not use any abrasive cleaner that could cause damage. Remember that if
the surface of the glass panel becomes scratched, this could lead to a dangerous failure.
While you have the oven door removed for cleaning, you may wish to remove
the inner glass panel for cleaning. Please refer to the illustrations below and
proceed as follows:
• Grip the top and the bottom of the inner door glass panel.
• Gently pull the
bottom of the inner
door glass panel
upwards (Fig.10).
• The securing clips
at the bottom of the
glass panel will pop
out and the glass
panel will be free to
remove.
IMPORTANT: Do not raise the panel more than 35° as it can damage the securing clips.
NOTE: If the top securing clips do not also pop out when pulling the
bottom of the glass panel upwards, then pull the top of the glass panel
upwards until the top also pops out.
• After cleaning,
insert the glass
panel correctly
back into the door
in the reverse order
(Fig.11). Ensure
the securing clips
slot back into place
and the glass panel
locks into place
securely.
IMPORTANT: Remember where the panel of glass is removed from so you can
reassemble the door correctly. Do not mix the glass panels up or rearrange the order.
WARNING: Placing the glass panels back in the door incorrectly could cause damage
and could lead to the door exploding.
Fig. 10
Fig. 11