45W Staple / Nail Gun
AFTER SALES SUPPORT
(toll free) MODEL No.: PCT161 • 07/2019 10366
e-mail: info.aldi@positecgroup.com
AUS
13
1300 889 028
AUS
Operation
1. On/off switch (6) (see fig. B)
Plug the power cord into the mains power supply and turn the switch on.
To start the machine, press down the On/Off switch (6) on the position
marked “I”.
To switch off the machine, press down the On/Off switch (6) on the
position marked “O”.
Warning: Switch off the machine and disconnect it from the
power source immediately when not in use.
2. To operate the staple gun (see fig. C)
1) Firmly press the nail/staple head (5) against the workpiece until there
is no gap between the nail/staple head (5) and the workpiece.
2) Only push the safety switch (1) to the marked “on” place.
3) Briefly press the trigger (2) and then release again.
Note: Remove all nails (10) / staples (9) from the magazine after
each use.
Maintenance
WARNING: Remove the plug from the mains power socket
before carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power tool. Never use water
or chemical cleaners to clean your power tool. Wipe clean with a dry
cloth. Always store your power tool in a dry place. Keep all working
B C
Operation
To Next Page
Loading...