45W Staple / Nail Gun
AFTER SALES SUPPORT
(toll free) MODEL No.: PCT161 • 07/2019 10366
e-mail: info.aldi@positecgroup.com
AUS
15
1300 889 028
AUS
Environmental protection
Recycle unwanted materials instead of disposing of them as
waste. All tools, hoses and packaging should be sorted, taken to
the local recycling centre and disposed of in an environmentally safe way.
FAQ/Troubleshooting
Fault Cause Remedy
1. Product
does not start
1.1 Not connected to power
supply
1.2 Product not switched
on.
1.3 Power cord or plug is
defective
1.4 Other electrical defect
to the product
1.1 Connect to power
supply
1.2 Press down the “I”
on thee on/off switch
(6).
1.3 Contact customer
service
1.4 Contact customer
service
2. Product
does not
reach full
power
2.1 Extension cord not
suitable for operation with
the product
2.2 Power source has too
low voltage
2.1 Use a proper
extension cord
2.2 Connect to another
power source
3. Nails (10) /
staples (9) jam
in tool
3.1 Wrong size nails(10) /
staples (9)
3.2 Driver channel worn
3.3 Bent nails (10) / staples
(9)
3.4 Loose magazine/nose
screws
3.5 Broken/chipped driver
3.1 Use only
recommended nails (10)
/ staples (9) sizes
3.2 Replace nail / staple
3.3 Discontinue using
these nails (10) / staples
(9)
3.4 Tighten all screws
3.5 Replace nail / staple
For further inquiries or issues associated with your tool, call our
Customer Service Hotline on 1300 889 028 or email us at
info.aldi@positecgroup.com
FAQ / Troubleshooting
To Next Page
Loading...
General