14
AFTER SALES SUPPORT
support@scheppach.com.au
1300 855 831
MODEL: HCE2500 PRODUCT CODE: 64124 03/2019
AUS
Safety regulations HCE2500
5. Service
• Have your power tool serviced by a qualied repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualied persons in order to avoid a hazard.
Electrical safety:
m Caution: to avoid accidents and injuries from electric shocks:
• The plug and socket of an extension cable must be water-tight!
m Unsuitable extension cables can be dangerous as people can be harmed
by an electric shock!
• Protect the electric plug connections against moisture.
• If there is a risk of ooding, x the plug connections in an area that is safe from
ooding.
• Ensure that the mains voltage matches the specications on the rating plate.
• Connection to the mains must be carried out by an experienced electrician and
meet the requirements of the Australian standards.
• The electrical installation shall be according to national wiring rules.
• The device must only be connected to a mains socket via a residual-current circuit
breaker (RCD) with a rated leakage current of not more than 30 mA. Fuse: at least
13 ampere.
• Before each use, check the high pressure washer, cable and plug for damage.
• If the power cable for this high pressure washer is damaged, it must be replaced
by the manufacturer, a customer service agent of the same or a similarly qualied
person in order to prevent hazards.
• Do not pull the plug from the socket by the cable. Protect the cable from heat, oil
and sharp edges.
To Next Page
Loading...
Need help?
General
