1
AFTER SALES SUPPORT
support@scheppach.com.au
1300 855 831
MODEL: HCE2500 PRODUCT CODE: 64124 03/2019
Using the high pressure washer correctly
• The high pressure washer must be stood on a level, stable surface.
• It is recommended that you adopt the correct operating position every time you
use the high pressure washer with one hand on the gun and the other on the
lance.
• Never direct the water jet at electrical lines or the high pressure washer itself.
• Never use the high pressure washer in potentially explosive areas under any
circumstances!
• The operating temperature must be between +5 and + 50 °C.
• Do not cover or modify the lance or the spray nozzles in any way.
• The high pressure washer is designed to be used with cold or lukewarm water
(max. 50 °C); higher temperatures can damage the high pressure washer.
• Do not use water that is dirty, gritty or contains any chemical products, as these
could impair operation and shorten the life of the high pressure washer.
m Warning! Risk of explosion Do not spray ammable liquids.
m Warning! Water that has passed through the non-return valve is not drinkable.
m Warning! If cleaning agent gets into contact with your skin or into your eye,
rinse immediately with lots of clean water. Then consult a doctor or follow the steps
described on the safety data sheet or provided by the manufacturer of the cleaning
agent.
Water inlet connector (Fig. 1/2)
The quick connector (12) has a standard hose coupling system. Plug the hose cou-
pling of the supply hose (min. Ø 1/2“/13 mm) to the quick connector (12).
Always use a reinforced hose with a standard coupling for the water inlet. The hose
should be at least 6 m in length (not supplied).
A backow preventer must be installed between the drinking water and the high
pressure washer! Ask your local plumber about this.
AUS
Before operation HCE2500
20
To Next Page
Loading...
Need help?
General
