Glue Gun
AFTER SALES SUPPORT
(toll free)MODEL No.: PGG72H • 07/2019 10282
e-mail: info.aldi@positecgroup.com
AUS
10
1300 889 028
AUS
To switch off, turn off the mains power switch and pull the mains plug
out.
WARNING: Allow the unit to cool completely before storing.
The hot nozzle can cause damage.
NOTE: As the result of heat storage, the glue gun can also be used after
it has heated up without being connected to the mains. If the glue that
emerges becomes thick, insert the plug into the mains power supply again.
Warning: Disconnect the glue gun from the mains power
supply when not in use.
2. Gluing
Preparations for Gluing
The surfaces to be glued must be clean, dry and free of grease. A
smoother surface is also more ideal for gluing.
WARNING: Do not use inflammable solvents for cleaning!
The ambient temperature and the work piece to be glued must not be
cooler than +5 °C or warmer than +50 °C.
Warm rapidly cooling materials (e.g. steel) for better adhesion.
Gluing
1) Press the flow control trigger (5).
2) Apply the glue in dots around the edges of the workpiece surface.
For gluing flexible materials (e.g. textiles), apply the glue in a zig-zag
line.
B
To Next Page
Loading...