Glue Gun
AFTER SALES SUPPORT
(toll free) MODEL No.: PGG72H • 07/2019 10282
e-mail: info.aldi@positecgroup.com
AUS
11
1300 889 028
AUS
Danger of burning! The glue and the nozzle tip are heated to 200 °C.
Do not allow the hot glue to come into contact with persons or
animals. If hot glue touches the skin, immediately hold the spot for
several minutes under a stream of cold water. Do not try to remove the
glue from the skin.
3) After applying the glue, press the surfaces to be glued together
immediately for a stronger bond.
4) Press the glued surfaces together for approximately 30 seconds. To
assist with adhesion, apply a weighted load or clamp to the glued
junction for approximately 5 minutes.
5) Between individual gluing actions, place the gun on the support
stand / rest (6) .
6) Remove glue residue after cooling with a sharp knife. The glued
junction can be separated again by heating. The glued junction can
be painted.
WARNING: Do not place the heated glue gun on the support
stand or have the nozzle pointed downwards for a long
period of time when using! The glue will continue to slowly
flow from the nozzle!
WARNING: The glue gun should be switched off and allowed
to cool down after 12 hours continuous use.
Maintenance
WARNING: Disconnect the glue gun from the mains power
supply before making any adjustments or undertaking
maintenance procedures.
Keep the glue stick clean to prevent impurities from clogging the nozzle.
After the glue stick is inserted, do not pull it out from the gun.
After heated, if the glue gun is not used for more than 15 minutes, turn
off the power switch and disconnect from the mains power supply.
Avoid using the glue gun in a humid environment, which may result in
electric shock.
To Next Page
Loading...