22
22
AFTER SALES SUPPORT
1300 889 028 (toll free)
e-mail:
MODEL No.:
info.aldi@positecgroup.com
YLW6281D • 700234 • 01/2020
13. Troubleshooting
WARNING!
You must remove the battery pack(1) before
commencing any cleaning, maintenance or inspection work
procedures on the appliance. Install the battery pack (1) to the machine
when safe to do so.
Symptom Possible Causes Solution
The Wet & Dry
Vacuum suddenly
stops during
operation.
Overload and battery
temperature too
high
Relieve the load on the
machine immediately and
allow cooling for approx.
30 seconds by running the
machine on no-load.
Low battery capacity Charge the battery pack.
Suction
decreases
Blocked hose (18)
Gently remove obstruction
using a long stick
Tank (6) has
reached 2/3 full or is
completely full with
waste and debris
Fully empty tank(6)
Noise of
vacuum
changes
and suction
decreases
HEPA filter (13) is
dirty and clogged
Clean the HEPA filter (13)
Tank (6) has
reached 2/3 full or is
completely full with
waste and debris
Fully empty tank (6)
Appliance will not
operate when the
tool is switched
on
Incorrect On/Off
switch (8) mode
selected
Select the Mode “I” in the
On/Off switch (8)
Battery pack (1) is
not installed.
Install the battery pack (1)
For further inquiries or issues associated with your tool, call our
Customer Service on 1300 889 028 or email us at
info.aldi@positecgroup.com
To Next Page
Loading...
