Operation and functioning
25
GB IRE
AFTER SALES
SUPPORT
GB
IRE
00800 34 99 67 53
meister-service@meister-werkzeuge. de
4. Disconnect the charger from the mains after 3 hours.
5. Pull the mains plug out of the charger.
6. Let the cordless screwdriver cool down to room
temperature if was heating up during the charging
process.
The cordless screwdriver is now operational.
Operation and functioning
Inserting tools
Bits with a length of 50 mm or more can be inserted
directly in the bit receptacle
7
. Proceed as follows to
properly fit all other bits:
1. Insert the magnetic bit holder
12
up to the stop
point in the bit receptacle.
2. Select a bit that corresponds to the screw.
3. Insert the selected bit up to the stop point in the
magnetic bit holder.
Switching the device on and off
NOTICE!
Risk of damage!
Driving screws in too far poses a risk of over-
winding. This could damage the cordless
screwdriver and the workpiece.
To Next Page
Loading...
Need help?
General
