EN
FR
ES
Technical Data
WARNING : Do not stare directly at the laser beam.
A hazard may exist if you deliberately stare into the beam, please observe all safety rules as follows;
●
●
●
●
●
CAUTION: Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure
Intended use
This circular saw is design for DIY, wood-cutting and soft metal cutting applications,
WARNING: Do not cut any masonry, glass, tile or plastic with this saw. A dull blade will cause
slow, inefficient cutting overload on the saw motor, excessive splintering
●
●
●
Supervision is required when inexperienced users operate the tool.
The laser shall be used and maintained in accordance with the manufacturer’s instructions.
Never aim the beam at any person or an object other than the workpiece.
The laser beam shall not be deliberately aimed at personnel and shall be prevented from being
directed towards the eye of a person for longer than 0.25s.
Always ensure the laser beam is aimed at a sturdy workpiece without reflective surfaces. I.e. wood
or rough coated surfaces are acceptable. Bright shiny reflective sheet steel or the like is not
suitable for laser use as the reflective surface could direct the beam back at the operator.
Do not change the laser light assembly with a different type. Repairs must be carried out by the
laser manufacturer or an authorized agent.
DO NOT use any abrasive wheels.
DO NOT use under wet conditions or in the presence of flammable liquids or gases.
DO NOT let children come in contact with the tool.
Voltage
No load speed
Blade size
Max cutting depth
DC -20V
3400/min
4-1/2”
1-11/16” @90degree 1-1/8” @45degree
- 09 -
To Next Page
Loading...