ALEAPOW K4 - Operation Procedures; Mounting the Extraction Adapter; Adjusting Cutting Depth and Angle; Switching the Saw On and Off

Mounting the Extraction Adapter
Adjusting the Cutting Depth
Adjusting the Cutting Angle
Switching On and Off
Note: For safety reasons, the On/Off switch cannot be locked; it must remain pressed during
the entire operation.
EN
FR
ES
Operation
Before any work on the power tool, remove the battery.
Fasten the extraction adapter to the dust port without tools.
●The extraction adapter may not be mounted when no
external dust extraction is connected. Otherwise the
extraction channel can become clogged.
●Do not connect a dust bag to the extraction adapter.
Otherwise the extraction system can become clogged. To
ensure optimum extraction, the extraction adapter must be
cleaned regularly.
●Loosen depth adjustment knob (16)
●Adjust the desired cutting depth
●Tighten depth adjustment knob again.
When setting the cutting depth, use the reference mark
to the side of the cutting-depth scale.
It is best to place the machine on the face side of the blade
guard.
●Loosen angle adjustment knob (9)
●Tilt the saw side-wards.
●Adjust the base plate to the desired angle between 0°to 45°.
●Tighten the bevel scale bracket.
To start the machine
●First push the lock-off button (13) back
●Then press the On/Off switch (14) and keep it pressed.
●When cut the wood, put the machine on the workpiece and
push it along the wood.
To switch off the machine
●First take out of the machine from workpiece.
●Then release the On/Off switch.
- 13 -
16
9
13
14