ALEAPOW K4 - Vibration, Extension Cords, and Tool Symbols; Vibration Exposure and Extension Cord Safety; Tool Symbols and Their Definitions

SAVE THESE INSTRUCTIONS SYMBOLS
●
The label on your tool may include the following symbols. The symbols and their definitions are as follows:
WARNING: Do not operate this tool for long periods of time. Vibration caused by the operating
action of this tool may cause permanent injury to fingers, hands, and arms. Use gloves to
provide extra cushion, take frequent rest periods, and limit daily time of use.
When using an extension cord, be sure to use one heavy enough to carry the current your product
will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and
overheating. The following table shows the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number,
the heavier the cord.
V
A
Hz
W
min
no
volts
amperes
hertz
watts
minutes
Alternating current
Direct current
no load speed
Class I Construction (grounded)
earthing terminal
safety alert symbol
Read instruction manual before use
Use proper eye protection
Use proper hearing protection
Use proper respiratory protection
Class II Construction (double insulated)
/min or rpm revolutions or reciprocation per minute
SPM Strokes per minute
or AC
or DC
- 04 -