The SMARTSMOKE11 is a smoke detector for the detection of fire in the first phase. In case of smoke development, the SMARTSMOKE11
will give a loud alarm tone of at least 85dB (A). The SMARTSMOKE11 can be connected and then the alarm will be reported in the TUYA app
and a scenario can be triggered. It is advised to test the smoke detectors every week using the test button on the smoke detectors. Keep this manual
in a safe place or in the meter cupboard.
RECOMMENDED MOUNTING PLACES FOR THE SMARTSMOKE11:
• Place at least one smoke detector in the vicinity of the bedrooms. Make sure that an exit remains accessible or choose an escape route. Place the
detector where the escape route is, so that the smoke detector would go off before it would become inaccessible.
• Make use of several detectors to increase safety in such a way that the escape route remains accessible.
• Place at least one smoke detector on each floor of your home.
• Place an Alarm at least in every bedroom where smoking is taking place or where there is equipment that could cause a fire.
• Smoke, heat and combustion products will first pull up to the ceiling. After that, the smoke, heat and combustion products will continue horizontally.
• If you mount the detector to the ceiling, keep a minimum distance of 50 cm from the wall and 61 cm from a corner. Smoke, heat and combustion
products will not get into a corner either.
DO NOT INSTALL IN THE FOLLOWING LOCATIONS:
• The shower or bathroom; water damp might cause a false alarm and the moist environment might damage the detector.
• The garage: The car exhaust might cause a false alarm.
• In front of a fan or nearby the exhaust of an air conditioner or heater.
• In a ceiling nook.
• In rooms where the temperature could reach below -10°C or beyond 40°C.
• Do not paint or otherwise cover this smoke detector.
INSTALLATION INFORMATION:
Attach the ceiling plate using the included plugs and screws to the ceiling on a location of choice. Wall moun-
ting is not recommended for smoke detection.
The battery for connecting the detector to Wi-Fi is already inserted in the detector. Only the activation plate
needs to be removed.
The built-in battery lasts about 10 years. However, the battery for the wireless WiFi connection lasts only 3
years. If the battery needs replacing, remove the module from the back of the device to replace the battery
(CR123A).
Turning the detector on the ceiling plate switches it on automatically.
Once the smoke detector is installed correctly the green LED will light up every 49 seconds, 4 seconds later the red LED will light up briefly. This
indicates that the SMARTSMOKE11 is working correctly, it is important to test the unit weekly.
EN
Do not place here
Place near here
Minimum distance
CR123A
8
To Next Page
Loading...
Need help?
General
