13
4.8 Moon phase:
The moon phase display is linked to the date, month and year setting. The following moon phases can be
displayed:
New moon Full moon
Crescent moon Waning moon
First quarter Last quarter
Waxing moon Ashen moon
4.9 Maximum / Minimum memory:
Use the MAX/MIN button to display the following maximum and minimum values one after the other:
Max. outdoor temperature - Min. outdoor temperature - Max. outdoor humidity - Min. outdoor humidity -
Max. indoor temperature - Min. indoor temperature - Max. indoor humidity - Min. indoor humidity - Max.
‘Feels like’ temperature - Min. ‘Feels like’ temperature - Max. ‘Wind chill’ temperature - Min. ‘Wind chill’
temperature - Max. ‘Wind index’ - Min. ‘Wind index’ - Max. ‘Dew point’ - Min. ‘Dew point’ - Max. air pres-
sure - Min. air pressure - Max. average wind speed - Max. wind gust - Max. rainfall.
The lower part of the display shows the day and time at which the concerned maximum of minimum value
was measured.
Press and hold the MAX/MIN for 2 seconds to reset the maximum and minimum values.
4.10 Display lighting:
Use the HI-LO-AUTO switch at the rear of the indoor unit to set the display lighting
AUTO: the display lighting follows the ambient light: at low ambient light the display lighting also decreas-
es, at strong ambient light the display lighting increases.
Hi: display lighting set to maximum level
Lo: display lighting set to minimum level (press the ALARM / SNOOZE button on top of the indoor unit to
set the display lighting to the maximum level. This light switches o again 5 seconds after releasing the
button.
While the weather station is searching for the radio signal for the clock function, you cannot switch the
display lighting on Hi continuously. When pressing the ALARM/SNOOZE button, the lighting does
switch on, but will switch o again after 5 seconds. As soon as the clock has found the radio signal, or when
stopping the search by briey pressing the RCC button, the display lighting switches on continuously.
4.11 Outdoor unit reception indication:
The upper left part of the indoor unit’s display shows the signal strength of the outdoor unit.
Upon receiving data from the outdoor unit, the antenna symbol ashes 2x.
No sensor
detected
Searching for
a sensor
Connection lostAverage
reception
Good reception
To Next Page
Loading...
Need help?
General
