EasyManua.ls Logo

Alecto WS-4900 - Positioning; Clock

Alecto WS-4900
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
3.3 Positioning:
Indoor unit:
You may choose to suspend the weather station from a wall using a
simple screw or to use it as a desk model using the supplied table stand.
In any case, never place the weather station in direct sunlight or nest to a
heat-radiating lamp or stove.
Outdoor unit:
You may choose to place the outdoor unit onto a at surface (e.g. a fence or railing) or to mount it on a pole
(excluded). In any case, make sure to position the unit at least 1.5 meters above the ground, standing freely
in the rain and wind.
General installation and placement tips:
• First check whether the outdoor unit is within range of the indoor unit before permanently installing it.
Maintain a distance of a maximum of 30 meters between the outdoor unit and indoor unit.
• Make sure the outdoor unit is placed at least 1.5 meters above the ground and that the unit is openly
standing in the rain and wind.
• For the rain meter to work as accurately as possible, the outdoor unit must be as horizontal as possible.
To do this, use the built-in spirit level on top of the outdoor unit.
• To be able to indicate from which direction the wind is coming from, the outdoor unit must be oriented
towards the north. See the indication N on top of the outdoor unit for this. Use a precise compass (ex-
cluded) to properly orientate the unit.
• Ensure that the outdoor unit is hanging or standing freely. Particularly the wind speed meter and wind
vane must hang in direct wind.
• Find a location where the chance of blowing leaves is minimal. Leaves blown into the rain collector can
block the rain meter or inuence the measurement results. In any case, we recommend that you place
the outdoor unit in such a way that it is fairly easy to remove any blown leaves and replace the batteries
in the outdoor unit.
• Of course, you may rst keep the outdoor unit within reach for a week to test all its functions. Only per-
manently install the outdoor unit after everything is functioning properly.
3.4 Clock:
Introduction
The WS-4900 is provided with a built-in DCF receiver which receives the DCF time signal from Frankfurt.
This signal ensures that the clock shows the time very accurately, provided a strong enough signal is being
received.
>1,5m
N
rubber
pads
horizontal
setup