MAINTENANCE
4. Cleaning the
Spa
Detergent residues and dissolved solids from bathing suits and chemicals will gradually accumulate in the
spa’s water.
To clean the spa, use soap and water then rinse.
Note: Do not use hard brushes or abrasive cleaners.
EMPTY,DEFLATE AND STORAGE
3.
Spa Storage
•
Make sure all water is drained from the spa and pump system. This is essential to extend the life of the spa.
We recommend the use of a wet/dry vacuum to blow out or suck up water from the spa pipes and pump lines.
•
Remove the filter cartridge.
•
It is recommended you store the spa in its original package in a warm dry place.
Note: Plastic becomes brittle and susceptible to breakage when exposed to subzero temperatures. Freezing can
severely damage the spa. Improper winterization of your spa may void your warranty.
1.
Empty
2)
Unscrew cap from Water Outlet below air inlet valve of Spa.
Ensure the Drainage Plug
(See the “ Part f ” picture)
is still
inserted to prevent unexpected draining.
3) Screw
Inflation
Hose
(See the “Part c” picture)
onto the Water Outlet and direct open the end of inflation hose
appropriately.
4) Remove the Drainage Plug
(Part f
)
from the floor of the Spa, so water can flow out
(Fig.5).
5)
Once drained use a sponge to absorb excess water, then you MUST
operate air jet function for at least 30
seconds to
drain the water from the air pipeline.
6) When draining is finished, remove the
Inflation
Hose
(Part c)
and replace the Drainage Plug
(Part f
)
and water outletcap.
Fig. 5
10
Remove the Spa plug from the electrical mains.
1)
2.
Deflate
1)
Find the black 1-way valve on the Spa
(See the Fig.3)
2) Fully unscrew and remove rapid deflation air valve by turning anti-clockwise to allow the air to escape.
3) Fold away the Spa carefully directly and removing as much air as possible through the open valve.
To Next Page
Loading...