CODE
CAUSE SOLUTION
FC
Control Panel Error Codes
HL
SL
SH
When filtration system has worked for
approx.168 hours, “FC”will appear
on display. Red light will still be lit on
filter, pump will not be operational.
Heating system will not work, and red
light will be out on heater.
Over Temperature/ Temperature Issue
11
Unplug from mains and wait. Temperature should start to reduce
and return to normal range.
Temperature Issue
Water Temperature ensor issue
Call for service on 833-926-2323 or hello@aleko.com
Clean or replace a new Filter Cartridge (Part d).
Once
done,
press“FILTER”
button again.
“FC”
code will disapper,
and
the watertemperature will be displayed. All functions will
return
to normal.
Problems Probable Causes Solutions
Jet system
does
not operate
---Air pump is too hot
---Something is wrong with the
power box
---Unplug the air pump. After the air pump has cooled, insert the
plug and press the Jet button to activate.
--- Call for service On 833-926-2323 or hello@aleko.com
Heating system
does not operate
---Temperature set too low
---Dirty fi
lter cartridge
---Improper water levels
---Heating element failed
re
Filtering system
does not operate
---Dirty filter cartridge
---Filter screwed on too tight
---Voltage too low or incorrect frequency
---Clean/replace the filter cartridge in time.
---Loosen the Filter slightly
---Ask professional
electrician to check whether the household input
voltage or frequency is normal
Spa leakage
---Spa is torn or punctured
---Use provided repair patch
Water not clean
---Insufficient filtering time
---Dirty filter cartridge
---Improper water maintenance
---Increase filtration time.
---Clean/replace the filter cartridge.
---Refer to the chemical manufacturer’s instructions.
Display temperature
is higher than 104°F,
after stopping heating
function/ HL Code
Displayed & Beeping
---Residual water in the Spa will
continue to be heated by residual
temperature
---Unplug from manins and wait 20 minutes. The temperature will start
to reduce and return to normal
Water inlet through filter system may
be blocked
---
--- Clean the inlet
--- Call for service on 833-926-2323 or hello@aleko.com
---Set
to
a
higher temperature
(68°F~
104°F) than current water temperatu
---Clean/replace
the
filter cartridge
in
time.
---Add
water
to
specified
levels.
---Call for service, On
833-926-2323
or hello@aleko.com
TROUBLESHOOTING
Here are some helpful tips to help you to diagnose and rectify some common sources of trouble.
To Next Page
Loading...