. .
35
START TIMER PROGRAMMING: (TEST and ADJUST)
1. Press the button twice on the transmitter to start the vehicle.
2. If the engine starts:
a. Press the
button twice on the transmitter to stop the engine. You
have completed this programming successfully.
b. Press the
button on the transmitter to exit the program mode.
There will be 3 long chirps and 3 parking light flashes for confirmation.
3. If the crank time is too long, (Engine is running, while the starter still
cranks):
a. Press the
button twice on the transmitter to stop.
b. Press the
button on the transmitter to set proper Start Timer.
1 chirp and the LED pause will confirm this programming is entered.
(Decrease Start Timer is necessary.)
c. Repeat the step1 4.
4. If the crank time is too short, (Engine cranks but does not start):
a. Press the
button twice on the transmitter to stop.
b. Press the
button on the transmitter to set the proper Start Timer.
The 1 chirp and the LED pause will confirm this programming is
entered. (Increase Start Timer is necessary.)
c. Repeat the step1 4.
In this test mode, the system can test the Zone 2 (Instant ground trigger),
the Zone 3 (Door trigger), and the Zone 1 and Zone 4 (2 stage shock sensor)
sensitivity. The installer can save time to test the 2 stage shock sensor sensitivity
and sensor without using the traditional arming/disarming procedures to test
the sensors.
Enter:
1. Turn the Ignition switch
ON and OFF
3 times and leave it in the
OFF
position.
2. Press the valet/program switch (10) times and hold it in on the 10
th
press, until (5) five chirps with (1) long chirp is heard, then release the
valet/program switch. You are now in the
START FEATURE #2
PROGRAMMING MODE
.
a. Test the Zone 2 / Instant Ground Trigger & Zone 3/Door Trigger:
Press and release the transmitters
and buttons at the same time
once. [1] LED flash and [1] chirp will indicate the system is in Zone
2/ instant ground trigger and Zone 3 /Door trigger test mode.
PROGRAMMING
ALARM TEST MODE
To Next Page
Loading...