QUICK
SETUP
n
Connect your source (instrument, mic, mixer) to either of
MIDIVERB
II's
inputs; both inputs if you have a stereo signal.
n
Connect
the
MIDIVERB
II
outputs
to
your
instrument
amp(s)
or stereo mixer returns.
n
Set the MIX control to 50/50
n
Start the
source
signal.
n
Turn
the
INPUT control
clockwise
until
the
green SIGNAL
LED stays on (when signal is
present)
and
the
red OVLD
(overload) LED flashes occasionally on peaks.
n
Turn
the OUTPUT
control
clockwise to the
volume
level
you desire.
n
Change Programs manually by pressing any
two
numbered
buttons
00-99
n
Set
the
MIDI
receive channel: Press
CHAN
followed
by two
numbered
buttons 01-l
6.
n
Assign Programs to MIDI Patch numbers:
Press PATCH followed by two numbered buttons 01-32.
Press PRGM followed by two numbered buttons
00-99
Hold STORE and press PATCH.
n
The system always reverts to Program mode (PRGM LED on).
Need help?
General
