T2 Connects master rectifier control signal U9 pins 13 and 14 to stereo dual switch S6
(Slave section).
T3 Connects output of master noise gate detector to slave gate LEDs, depending on
the state of the stereo/dual switch.
T4 Connects master bypass switch S10 to slave stereo dual switch S6. Used to
determine the correct source of input to the gain reduction LEDs, depending on the
state of the stereo/dual switch.
T5 Connects master bypass switch to stereo/dual switch to provide the correct path for
the VCA control voltage signal, depending on the state of the stereo/dual switch.
T6 Connects the master gain reduction LEDs to the stereo/dual switch.
T7 Connects channel A input (U2 pin 8) to input side of monitor switch 9.
T8 Connects channel A final output (Just prior to -10/+4 switch S2) to output side of
monitor switch S9.
T9 Connects channel B input (U2 pin 8) to input side of monitor switch 9.
T10 Connects channel B final output (Just prior to -10/+4 switch S2) to output side of
monitor switch S9.
T11 Connects the slave gain reduction LEDs to the stereo/dual switch.
Alesis 3630 Compressor Service Manual 1.00 4 12/11/02
To Next Page
Loading...
