Alesis 4 - Realtime Modulation Control Setup

Advanced Applications – Chapter 6
MidiVerb 4 Reference Manual 59
➂ Turn the [VALUE] knob to select a MIDI program change number from 000–127
to be remapped.
➃ Press the [D] button to select the Program field.
The Program field will flash to indicate it is selected for editing.
➄ Turn the [VALUE] knob to select a MidiVerb 4 Program for the selected MIDI
program change message to be re-mapped to (User 000–127 or Preset 000–127).
If the [VALUE] knob is turned counterclockwise so that the value goes below User 000,
the upper display will change to Pset indicating you are selecting a Program in the Preset
bank.
Sysex Storage
In order to send and receive Program information via Sysex (System Exclusive)
dumps using a computer, or some other Sysex storage device, or another MidiVerb 4:
➀ Connect the other device’s MIDI OUT to the MidiVerb 4’s [MIDI IN]. Connect the
MidiVerb 4’s [MIDI OUT] to the other device’s MIDI IN.
This provides two-way communication between the devices.
➁ Press [UTIL], then press [EDIT/PAGE] button until page 6 is selected.
The [UTIL] button will now be flashing, and the display will read:
Send MIDI Sysex: A ll
➂ Use the [VALUE] knob to select All User Programs (All), or the currently selected
Program (Buffer), or the Program Change Table (Table).
➃ Set the receiving MIDI device to receive or record the MIDI information about to
be sent from the MidiVerb 4.
➄ Press the flashing [UTIL] button to transmit.
The [UTIL] button will briefly flash rapidly and the display will read:
Transmitting Sysex...
➅ When you send a Sysex dump back to the MidiVerb 4, it will automatically go
into receive mode (you do not have to do anything special). When this occurs,
the display will momentarily read:
RECEIVING MIDI DATA...
Note: If an error occurs while receiving Sysex data back into the MidiVerb 4, the
display will briefly indicate:
!!! SYSEX DATA ERROR !!!
If this occurs, try sending the data again. If the problem persists, it may indicate a
bad MIDI cable connection or a problem with the data itself.