What to do if my Alesis Speakers have no sound?
If your Alesis Speakers produce no sound, there might be several reasons. First, ensure that the input cable connections are secure. Secondly, check the input level on the back panel and increase it if it's too low. Finally, verify that the AC power is on; the blue LED on the front should be illuminated. Check the power switch and the power input cable.
Why are my Alesis M1 Active MKII Speakers producing a distorted output?
If you are experiencing distorted output from your Alesis Speakers, the power amplifier may be overloading the speakers. Try turning down the level. If the problem persists, damaged speaker components might be the cause. Swap the channels to see if the problem follows the speaker; if it does, contact Technical Support.
How to eliminate hum or buzz from Alesis Speakers?
A hum or buzz in your Alesis Speakers is often due to a ground loop between the source and the speaker. To resolve this, use balanced cables and ensure that the M1 Actives are on the same AC power circuit as the mixer.
Why do my Alesis M1 Active MKII have unfocused sound and muddy bass?
Unfocused sound, muddy or missing bass frequencies in your Alesis Speakers can occur due to several reasons. First, check the + and - connections from the mixer to the input to ensure they are in phase and verify 'pin 2 is hot'. If you're using a subwoofer, install port plugs. Alternatively, the issue might be a poor mix; compare your mix to a commercial CD of a similar style to determine if you need to remix your track.
Details on unpacking, contents, and initial checks for the M1 Active Mk2 speakers.
Overview of powered monitors and the biamplification concept.
Discusses flat frequency response, driver construction, and magnetic shielding.
Technical details on the bi-amplification and electronic crossover system.
Information on the switching power supply, cabinet construction, and port design.
Explains the benefits of offset tweeter placement for improved frequency response.
Guidance on minimizing acoustic reflections for optimal monitoring.
Recommends positioning tweeters inward for accurate stereo imaging.
Advice for horizontal speaker setup, including placement behind the meter bridge.
Guidance for vertical speaker setup to simulate consumer listening environments.
Performing a playback check in a larger listening triangle for mix evaluation.
Details on plugging ports to tailor low-frequency response to room acoustics.
Instructions for setting up speaker connections, power, and grounding.
Guidance on setting the input level for optimal system dynamic range.
Definition and evolution of surround sound systems in audio playback.
Discusses the role and setup of center speakers in music production.
Details studio placement for center speakers in surround setups.
Recommended positioning for rear surround speakers.
Speaker requirements for music vs. video surround mixing.
Table of common issues, causes, and solutions for M1 Active/Surround systems.
Instructions for cleaning speaker cabinets and general maintenance.
Guidance on seeking professional servicing and obtaining repairs.
Details on cabinet materials, construction, and port design.
Technical specifications of the low and high frequency drivers.
Specifications for the crossover network and amplifier components.
Details on frequency response, SPL, power consumption, and weight.
To Next Page
General