Alesis Micron - Mode Jumping Shortcuts; Program Mode Jumping; Setup Mode Jumping; Pattern Mode Jumping

8
Mode Jumping Shortcuts
Access each of these shortcuts by holding one of the [programs], [setups],
[patterns], or [rhythms] buttons and then pressing one of the other buttons.
[programs]
Press [setups]: set the most recent part’s program.
Press [patterns]: set the pattern’s program.
Press [rhythms]: set the most recent drum’s program (for drum
programs only).
[setups]
Press [programs]: jump to the most recent part’s program.
Press [patterns]: jump to the pattern of the most recent part (if any).
Press [rhythms]: jump to the rhythm of the most recent beat (if
any).
[patterns]
Press [programs]: jump to the pattern’s program.
Press [setups]: set the most recent part’s pattern.
Press [rhythms]: (no shortcut).
[rhythms]
Press [programs]: jump to the program of the most recent drum.
Press [setups]: set the most recent beat’s rhythm.
Press [patterns]: (no shortcut).
Other Shortcuts
In most areas, pressing the control knob twice (double click) restores the default
value.
Button-specific shortcuts:
[octave]
Press both [octave] buttons simultaneously to return to the default
octave range of C3 through C6.
[tap]
Hold [tap] and turn the control knob for fine control over the tempo.
[programs]
When editing a parameter, hold down the control knob and wiggle an
(x/y/z) knob to assign the knob to that parameter.
[setups]
For each part, hold down [setups] and move a slider or the pitch wheel
to jump to the controller assignment options for that part. Do the same
with the (x/y/z) knobs.