Need help?Do you have a question about the Alesis PercPad and is the answer not in the manual?
Connect the PercPad's main output to a speaker or amplifier system using standard 1/4" cables.
Connect a set of 1/4" headphones to the headphone input for private listening.
Connect the included power adapter to the DC input and then to a wall outlet.
Connect an optional footswitch using a 1/4" mono cable for bass drum triggering.
Connect a kick pad or trigger using a 1/4" mono cable to the kick pedal input.
Indicates the location for mounting the PercPad module onto a stand.
Details the main strike pad and the pad/mode indicator LEDs on the top panel.
Explains the LCD screen for parameter display and the VALUE +/- buttons for adjustments.
Describes the SELECT +/- buttons used for navigating through modes and parameters.
Adjusts the overall volume level of the PercPad's output.
Details the DC input for the power adapter and the power switch for turning the unit on/off.
Explains the main audio outputs (L/MONO, R) for connecting to sound systems.
Specifies the 1/4" headphone jack for private monitoring.
Covers the input for a kick pedal and the switch to select between footswitch or trigger types.
Describes the MIDI OUT port for sending MIDI data to external devices.
Guide on using SELECT +/- to enter modes and VALUE +/- to adjust parameters.
Adjusts the pitch (TUNE) and reverb amount applied to a selected pad.
Change the sound voice assigned to a specific pad (1-25).
Sets the stereo position (PAN) and input gain (SENSITIVITY) for each pad.
Adjusts the pad's volume level and outgoing MIDI note number.
To Next Page
General
