2
QUICK SETUP GUIDE
1. Make sure all items listed on the front of this guide are included in the box.
2. READ SAFETY INSTRUCTION BOOKLET BEFORE USING THE PRODUCT.
3. Study this setup diagram.
4. Place the Performance Pad in an appropriate position for operation – either on a flat surface, such as a table or
attach to a drum set clamp mount (sold separately).
5. Make sure all speaker devices are turned off and all volume knobs/faders are at “zero.”
6. Connect all input sources as indicated in the diagram.
7. Connect the outputs to headphones, and/or powered amplifier stereo system.
8. Plug in both power adapters and other devices into AC power.
9. Switch everything on in the following order.
a. Performance Pad.
b. Any external devices.
c. Any external speakers.
10. When turning off, always reverse this operation by,
a. Any external speakers.
b. Any external devices.
c. Performance Pad.
NOTE: Speakers, external sound device, additional triggers and CD player are NOT included.
GETTING STARTED
This section will cover how to begin using your Peformace Pad. Be sure that your setup matches the diagram as
previously shown.
• Be sure that the Performance Pad is powered on.
1.
While the unit is powered on, turn the volume up on the back panel half way.
2.
Strike the drum pads with your drum sticks. This should produce a sound.
ORDER DIRECTLY TODAY AT: www.BulbAmerica.com or CALL TOLL FREE 888-505-2111
To Next Page
Loading...
Need help?
General
