MIDI Transfer and Storage Operations: Chapter 9
To send a single Program via MIDI to a different Program number:
¿ Follow steps ¿ through ¬ in the instructions above.
¡ Press [PAGE ] to advance the cursor to the lower section of the display.
¬ Use the CONTROLLER [D] slider to select a Program number to send the
Program to.
√ Press [STORE] to transmit the data out the MIDI Out connector.
The procedure is similar for sending Mixes. Page 5 of the Store function allows you to
send any one of the Mixes. In the case of storing a Mix, you may want to store each
of the Programs used in the Mix. The “SEND ALL TO MIDI” command in Store mode
is an easy shortcut to this (see above).
QS7/QS8 Reference Manual 125
To Next Page
