Need help?Do you have a question about the Alfa Laval EPC-400 and is the answer not in the manual?
General| Brand | Alfa Laval |
|---|---|
| Model | EPC-400 |
| Category | Control Unit |
| Language | English |
The EPC-400 control unit is used in ALCAP separation systems.
The EPC-400 monitors and controls the separation process, including sequences and alarms.
Details the design of the EPC-400, covering its front panel, internal components, and power supply.
The process operation is described in the 'Operating Instructions' manual.
Explains how parameter setting is performed initially at installation and during operation.
Recommends carrying out a lamp (LED) test once a month. No other regular maintenance is required.
Details corrective maintenance procedures, including fuses and related functions.
Provides instructions for replacing a faulty control module with a spare module.
Provides technical specifications such as mains voltage, power, frequency, cable area, outputs, and fuses.
Shows physical dimensions with diagrams and lists article numbers for different separator types.
Presents the electrical circuit diagram showing connections and components for the EPC-400.
Recommends wall-mounting via keyhole lugs and fastening lugs, advising against rubber dampers.
Recommends keeping cables short and separating signal/power cables inside the EPC cabinet.
Specifies cable entry points for left-hand and right-hand terminals to prevent electrical noise.
Explains terminal protectors shield circuit boards and the procedure for connecting cables after removal.
To Next Page