2Safety
All warnings in this manual are summarised on this page.
Pay special attention to this instructions below so that severe personal injury and/or damage to the valve are avoided.
2.3 Safety precautions
Installation:
Always read the technical data thoroughly (see chapter 6 Technical data)
!
Never touch the valve or the pipelines when processing hot liquids or when sterilising
Never dismantle the valve with valve and pipelines under pressure
Never dismantle the valve when it is hot
Operation:
Never dismantle the valve with valve and pipelines under pressure
!
Never dismantle the valve when it is hot
Always read the technical data thoroughly (see chapter 6 Technical data)
Never touch
moving parts if the actuator is supplied with compressed air
Always rinse well with clean water after cleaning
Always handle lye and acid with great care
Maintena
nce:
Always r
ead the technical data thoroughly (see chapter 6 Technical data)
!
Never service the valve when it is hot
Never service the valve with valve and pipelines under pressure
Transportation:
Always ensure that compressed air is released
Always ensure that all connections are disconnected before attempting to remove the valve from the installation
Always drain liquid out of valves before transportation
Always used predesigned lifting points if defined
Always ensure sufficient fixing of the valve during transportation - if specially designed packaging material is available it
must be used
6
To Next Page
Loading...
Need help?
General
