Alfapilot XiHD - Thermal and Takeoff;Landing Detection

28
6.8.2 Config Thermals Values
 Minimum Climb for add Thermal to History: This parameter is used to limit the thermals that will
be stored in the INTERNAL thermal package. Only thermals with an average value higher than the
value entered in m/s will be stored.
 End of Thermal at lost meters: We indicate the meters that we must lose before SeRi FLY considers
that the current thermal has been lost, by default 30 meters.
6.8.3 Takeoff Detection
It allows us to indicate to the system the minimum values that must be exceeded so that the takeoff is
detected, both variations must be fulfilled. If only one is met, it is not considered take off.
 Minimum Variation of Speed, this value will indicate the minimum speed in km / h necessary to
consider the takeoff.
 Minimum Variation of Altitude, this value will indicate the minimum variation of Altitude
(barometric) in meters to consider the takeoff.
6.8.4 Landing Detection
It allows us to indicate to the system the maximum values that must not be exceeded during the indicated
time for the landing to be detected, both variations must be fulfilled. If only one is met, it is not considered
landed.
 Maximum Variation of Speed, this value indicates the maximum variation of speed in Km/h, if
during the configured time our average speed is lower than this value it will be considered Landfall.
 Maximum Variation of Altitude, this value indicates the maximum variation of altitude
(barometric) in meters, if during the configured time the variation of our average altitude is less
than this value it will be considered Landed.
 Maximum Time without Variations, establishes the maximum time in seconds for the calculation
of the variations of speed and altitude. A small time value can lead to false detections of landing.
6.8.5 Order WayPoints by Distance in Flight XC
Activating this option, in the "Flight Manager" in flight mode XC will order the WayPoints by the distance
they are from our point. In case it is deactivated, they will be ordered alphanumerically.
6.8.6 Show Track Duration on Map - Minutes
It is the time in minutes that the painting of the trace of our flight will last on the map screen, by default
"Always".
It is advisable to limit the time in hillside flights, or flights where we spend a lot of time flying over the same
area.