Alienware Area-51 m5550 - Installing a Memory Module (DIMM) into the System

Alienware Area-51 m5550 Technical Reference
61
Installing a memory module (DIMM) into the system
To install the DIMM, do the following:
1. Power OFF the notebook. Unplug the AC cord and all cables/devices
attached to the notebook. Remove the battery.
2. Place your hand on a large metal object momentarily to discharge any static
electricity. Place the notebook on a flat surface and fully close the LCD lid.
3. Locate and remove 9 Screw D’s on the System Device Cover.
4. Remove the System Device Cover. The DIMM socket is now seen as shown
below.
m5550-04-2007-techref.indd 61 4/6/2007 12:29:52 PM