Alinco DR-135 Mk III User Manual

05.2014
Packet Radio Users Guide
Cupertino ARES/RACES

Alinco DR-135 Mk III Specifications

General

Mode	FM
Receiver System	Double conversion superheterodyne
Sensitivity	0.20μV (12dB SINAD)
Selectivity	12 kHz (-6 dB), 28 kHz (-60 dB)
IF Frequencies	455 kHz
Audio Output	2 W

Summary

1 Ham Radio Packet Overview

Why use Packet Radio?

Explains the benefits of packet radio for message storage, retrieval, accuracy, and emergency communications.

2 Setting up the Packet Station

2.3 Connecting the parts

Provides step-by-step instructions for physically connecting all components of the packet system.

2.4 Power on sequence

Outlines the correct procedure and order for powering on the packet system equipment.

2.5 Application Startup

Guides users on launching and performing initial configuration of the Outpost software.

3. Setting up the TNC.

Interface Type Settings

Configures the TNC's interface type and device name within the Outpost software.

TNC Comm Port Settings

Establishes the correct serial communication port (COM port) for the TNC connection.

4. Setting up the BBS.

Select a BBS

Details how to select and configure a specific Bulletin Board System (BBS) within Outpost.

7. Connection Test.

Verify BBS Connectivity

Tests the packet system's ability to connect and communicate with the designated BBS.

3 Packet message addressing basics

1. Packet Address Header

2. Recipient Address and Message

5 Alinco DR-135 Radio Setup Details

Squelch Setting and Volume

Memory Mode and Frequency Selection

Changing Power Levels