6 Remote I/O Scanner
Publication 1747-IN060B-EN-P - June 2001
Baud Rate DIP Switch
The figure below shows the location of the DIP switch and the DIP switch settings
for the supported baud rates.
Required Tools and Equipment
Have the following tools and equipment ready:
• medium blade screwdriver
• termination kit (the package, containing resistors and a ring lug, which was
included with the scanner)
• approximately 38 cm (15 inches) of #20 AWG wire for grounding the drain
shield to the SLC chassis (for Series A retrofits)
• adequate length of RIO communication cable (Belden™ 9463) for your
specific application
IMPORTANT
For proper system operation, the baud rate of all devices on the
RIO link must be the same.
12
12
12
12
O
N
O
N
O
N
O
N
57.6K baud
115.2K baud
230.4K baud
230.4K baud
To Next Page
Loading...