Allen-Bradley 1747-SN - Summary of Changes; New Information

Remote I/O Scanner 7
Publication 1747-IN060B-EN-P - June 2001
Installation
Make sure you have set the DIP switch properly before installing the scanner.
Insertion
1. Disconnect power.
2. Align the full-sized circuit board with the chassis card guides. The first slot
(slot 0) of the first rack is reserved for the SLC 500 processor.
3. Slide the module into the chassis until the top and bottom latches catch.
ATTENTION
!
Before installation, make sure that your modular SLC power
supply has adequate reserve current capacity. The scanner
requires 600 mA at 5V dc.
IMPORTANT
Before installation, make sure that your modular SLC power
supply has adequate reserve current capacity. The scanner
requires 600 mA at 5V dc.
Card Guide
Module Release
Cable Tie