6 FLEX I/O AC Digital Output Modules
Publication 1794-IN103D-EN-P - July 2018
WARNING: Observe the following additional certification
requirements:
• This equipment is not resistant to sunlight or other sources of UV
radiation.
• This equipment shall be mounted in an ATEX/IECEx Zone 2 certified
enclosure with a minimum ingress protection rating of at least IP54 (in
accordance with EN/IEC 60079-15) and used in an environment of not
more than Pollution Degree 2 (as defined in EN/IEC 60664-1) when
applied in Zone 2 environments. The enclosure must be accessible only
by the use of a tool.
• This equipment shall be used within its specified ratings defined by
Rockwell Automation.
• The instructions in the user manual shall be observed.
• This equipment must be used only with ATEX certified Rockwell
Automation backplanes.
• Earthing is accomplished through mounting of modules on rail.
• Devices shall be used in an environment of not more than Pollution
Degree 2.
• Enclosure must be marked with the following: "Warning - Do not open
when energized." After installation of equipment into the enclosure,
access to termination compartments shall be dimensioned so that
conductors can be readily connected.
To Next Page
Loading...
