Need help?Do you have a question about the Allen-Bradley 1734-IB8S and is the answer not in the manual?
General| Manufacturer | Allen-Bradley |
|---|---|
| Product Type | Digital Input Module |
| Series | POINT I/O |
| Number of Inputs | 8 |
| Input Voltage Category | 24V DC |
| Input Delay | 1 ms |
| Isolation Voltage | 50V continuous |
| Module Location | POINT I/O system |
| Operating Temperature | -20 to 60°C (-4 to 140°F) |
| Connection Type | Removable terminal block |
| Compatibility | POINT I/O system |
Guidelines for determining if the POINT Guard I/O modules are suitable for your application and system.
Essential safety measures and warnings for proper installation and operation of POINT Guard I/O modules.
Requirements for safety applications, including performance levels and safety integrity levels for POINT Guard I/O modules.
General precautions for use, including environmental, electrical safety, and ESD considerations.
Initial steps for setting up POINT Guard I/O modules using the Logix Designer application.
Guide to adding and configuring safety digital input modules in the project.
Tasks required in RSNetWorx for DeviceNet before adding modules to a GuardLogix project.
Steps to add the POINT Guard I/O module to the controller project using Logix Designer.
Procedure to copy configuration signatures and safety network numbers between RSNetWorx and Logix Designer.
Guide for replacing modules in GuardLogix systems over EtherNet/IP, including configuration options.
Specific safety input parameters for the 1734-IB8S Series A module.
Specific safety output parameters for the 1734-OB8S Series B module.
Table listing calculated product failure rates (PFD, PFH, STR, MTTF) for various configurations.
List of configurable parameters for safety digital inputs in Logix Designer.
List of configurable parameters for safety digital outputs in Logix Designer.
List of configurable parameters for safety analog inputs in Logix Designer.
To Next Page
