Allen-Bradley 1734-IE4S User Manual

Point Guard I/O Safety Modules
Catalog Numbers 1734-IB8S, 1734-OB8S, 1734-IE4S, 1734-OBV2S
User Manual
Original Instructions

Allen-Bradley 1734-IE4S Specifications

General

Brand	Allen-Bradley
Model	1734-IE4S
Category	Control Unit
Language	English

Summary

Point Guard I/O Safety Modules User Manual

Chapter 1 POINT Guard I/O Overview

Safety Precautions

Essential safety guidelines for using POINT Guard I/O modules.

Programming Requirements

Chapter 2 Safety Inputs, Safety Outputs, and Safety Data

Safety Inputs (1734-IB8S)

Dual-channel Mode and Discrepancy Time

Safety Analog Inputs (1734-IE4S)

Safety Outputs (1734-OB8S and 1734-OBV2S)

Chapter 3 Guidelines for Placing Power Supplies and Modules in a System

Choosing a Power Supply

Guidance on selecting appropriate power supplies for the system.

Placing Series A Digital and Analog Modules

Placing Series B Digital Modules

Chapter 4 Install the Module

Precautions

Important safety and handling precautions before installation.

Prevent Electrostatic Discharge

Mount the Module

Step-by-step instructions for physically mounting the module.

Wire Modules

Guidelines and best practices for wiring modules correctly.

Chapter 5 Configure the Module in a GuardLogix Controller System

Set up the Module

Initial steps to configure POINT Guard I/O modules using Logix Designer.

Add and Configure Safety Digital Input Modules

Process for adding and configuring digital input modules.

Add and Configure Safety Digital Output Modules

Process for adding and configuring digital output modules.

Add and Configure Safety Analog Input Modules

Process for adding and configuring analog input modules.

Configure the Safety Analog Input Channel Operation

Assign the Operation Type

Configure Safety Connections

Requested Packet Interval (RPI)

Chapter 6 Configure the Module for a SmartGuard Controller

Set the Node Address

Procedure to set the unique node address for POINT Guard I/O modules.

Set Up Your DeviceNet Network

Configure the POINT Guard I/O Modules

Configuring safety inputs and outputs for POINT Guard I/O modules.

Configure Digital Safety Inputs and Test Outputs

Setting up digital safety inputs and test outputs for modules.

Configure Safety Analog Inputs

Display the parameters for editing, double-click each group of Dual Channel Safety Inputs

Chapter 7 Configuring Safety Connections between a GuardLogix Controller and POINT Guard I/O Modules on a DeviceNet Network

Configure the Module in RSNetWorx for DeviceNet Software

Tasks required in RSNetWorx to prepare modules for GuardLogix integration.

Add the POINT Guard I/O Module to the Controller Project

Steps to add the module to the GuardLogix controller project.

Complete the Safety Configuration

Copying configuration signatures and safety network numbers.

Download the DeviceNet Network Configuration

Verify Your DeviceNet Safety Configuration

Lock Safety Devices

Chapter 8 Replacing POINT Guard I/O Modules

The Safety Network Number

Resetting a Module to Out-of-box Condition

Replace a Module in a GuardLogix System on an EtherNet/IP Network

Procedure for replacing modules in an EtherNet/IP system.