Need help?Do you have a question about the Allen-Bradley 2080-LC10-12AWA and is the answer not in the manual?
General| Brand | Allen-Bradley |
|---|---|
| Model | 2080-LC10-12AWA |
| Category | Controller |
| Language | English |
Explains safety symbols like WARNING, ATTENTION, SHOCK HAZARD, BURN HAZARD, and IMPORTANT.
Provides guidance on controller installation in industrial enclosures to mitigate electrical interference.
Provides information for operating equipment in Class I, Division 2 hazardous locations.
Details procedures for safely disconnecting main power to the controller and system.
Explains the importance of hard-wired safety circuits like E-stop buttons and interlocks.
Provides guidelines for correctly implementing emergency-stop switches in control systems.
Outlines essential guidelines for wiring controllers, including separation and labeling.
Provides specific wiring information for controller inputs and outputs.
Explains the Micro800 controller's scan cycle and program execution process.
Details the parameters and their data types for the IPIDCONTROLLER function block.
Provides a step-by-step guide on how to perform the AutoTune function.
Explains the meaning of status indicators on the Micro810 controller unit.
Describes how to interpret input and output status indicators on the LCD module.
Lists potential error codes for the controller and recommended recovery actions.
Provides a comprehensive list of error codes and their corresponding recommended actions.
Presents a flowchart to help diagnose and recover from software and hardware problems.
Guides on configuring built-in Smart Relay function blocks using the LCD display.
Explains how to navigate the controller's LCD display menus and functions.
Provides steps to configure the Count Up (CTU) function block.
Details how to test the functionality of the CTU predefined function block.
Guides on configuring the On-delay Timing (TON) function block with sample parameters.
Explains how to test the operation of the TON predefined timer function.
Provides steps to configure the DOY (Day of Year) function block with sample parameters.
Details how to test the functionality of the DOY predefined function block.
Provides instructions on updating the controller's firmware using ControlFLASH.
Guides on setting up communication between RSLinx RSWho and the controller via USB.
Explains the process and implications of forcing I/O for troubleshooting and testing.
Describes how to check if I/O forcing is enabled in the controller using CCW.
To Next Page