Need help?Do you have a question about the Allen-Bradley 2080-OB4 and is the answer not in the manual?
General| Number of Outputs | 4 |
|---|---|
| Output Type | Sourcing |
| Voltage Rating | 24V DC |
| Voltage Category | 24V DC |
| Compatibility | Micro800 Controllers |
| Category | I/O Module |
| Type | Digital Output Module |
| Product Type | Output Module |
| Operating Voltage | 20.4…26.4V DC |
| Surge Current | 2A |
| Backplane Current Consumption | 50mA |
| Isolation | 1500V |
| Isolation Voltage | 1500V |
| Operating Temperature | -20°C to 55°C (-4°F to 131°F) |
| Storage Temperature | -40 to 85°C |
| Relative Humidity | 5 to 95% non-condensing |
| Current Rating | 0.5A per point, 2A total |
Details critical safety guidelines, warnings, and disclaimers for equipment use.
Covers 12/24V DC Sink/Source input and AC/DC relay output modules.
Describes non-isolated unipolar analog input and output modules.
Details pin designations and wiring procedures for various plug-in modules.
Details steps for configuring the DeviceNet plug-in and scanning the network.
Provides detailed specifications for digital I/O modules.
Lists detailed input and output specifications for analog modules.
Step-by-step guide to configuring plug-ins using CCW software.
Guide for updating the firmware of the DeviceNet plug-in.
Guidance on troubleshooting the Micro800 controller system.
Lists error codes specific to plug-in modules and recommended actions.
To Next Page