Need help?Do you have a question about the Allen-Bradley 22C-D038A103 and is the answer not in the manual?
General| Brand | Allen-Bradley |
|---|---|
| Model | 22C-D038A103 |
| Category | Controller |
| Language | English |
Provides ATTENTION notes regarding electrical shock hazards, ESD sensitive parts, and incorrect application or installation.
Explains that the drive does not provide short circuit protection and requires input fuses or breakers.
Provides ATTENTION notes regarding national codes and safely installing electrical equipment.
Discusses acceptable cable types, including unshielded and shielded/armored, with UL installation requirements.
Provides recommendations for I/O wiring, including wire types, insulation ratings, and separation from power wires.
Describes how drive speed and start commands are obtained from various sources and their override priority.
Covers CE conformity, Low Voltage Directive, and EMC Directive requirements for the drive.
Explains FCC compliance for Class A digital devices and potential interference in commercial environments.
Details pre-start checks including input connections, AC line power, digital control power, and DIP switch settings.
Describes the integral keypad, operator keys, and their functions for programming and control.
Provides step-by-step instructions on navigating and editing drive parameters using the integral keypad.
Lists parameters organized into Basic Display, Basic Program, Terminal Block, Communication, Advanced Program, and Aux Relay Card groups.
Lists parameters for motor data (volts, hertz, current), frequency limits, start source, and speed reference.
Covers parameters for digital inputs, relay outputs, opto outputs, analog inputs, and analog outputs.
Details parameters for language selection, communication format, data rate, node address, and loss actions.
Lists parameters for purge frequency, internal frequency, preset frequencies, accel/decel times, and PID settings.
Defines a fault as a condition that stops the drive and identifies two fault types: Auto-Reset/Run and Non-Resettable.
Lists fault types, descriptions, and corresponding corrective actions for various fault conditions.
Provides a table of common symptoms, their indications, and corrective actions for troubleshooting.
Details steps to manually clear faults using the keypad, Stop key, or by cycling power.
Describes conditions and parameter settings for automatically clearing Type 1 faults and restarting the drive.
Provides recommended AC line input fuse and circuit breaker information based on UL and IEC requirements.
Lists drive specifications including ratings, input voltage, output current, kVA, fuses, protectors, and enclosure volumes.
Covers electrical specifications like voltage tolerance, frequency tolerance, input phases, power factor, efficiency, and short circuit ratings.
Details control specifications including method, carrier frequency, accuracy, speed regulation, stop modes, and overload capability.
To Next Page