Allen + Roth A102002103 - Page 14

ASSEMBLY INSTRUCTIONS
14
Connect top beams (E1) to top beams
(E2) with beam connector (E8), using
bolts (NN) and flat washers (BB). Tighten
with wrench (Z2).
Hardware Used
x 12
NN
BB
x 12
Z2
x 1
M6 x 15 Bolt
M6 Flat Washer
M
6 Wrench
16.
Attach support beams (F1/F2/F3) to
side beam (D1/D2/D3/D4) using bolts
(DD) and flat washers (BB). Tighten
with wrench (Z2).
Hardware Used
x 8
DD
BB
x 8
Z
2
x 1
M6 x 20 Bolt
M6 Flat Washer
M6 Wrench
17
.
15-2.
Connect support beams (F1/F2/
F3) with beam connector (F7) using
bolts (CC), flat washers (BB) , spring
washers (EE) ,nuts (JJ)and cap
(OO).Tighten with wrench (Z2).
Hardware Used
x 8
x 8
x 16
x 8
x 2
Z2
M6 Wrench
x 8
CC
M6 x45 Bolt
BB
M6 Flat Washer
EE
Spring Washer
JJ
M6 Nut
OO
M6 Plastics Cap