7
ASSEMBLY INSTRUCTIONS
2. Connect the Post Corner (H) to the Post (A) with
Bolt (AA) and Flat Washer (FF), please pay
attention to the installation direction.Tighten
together with the Wrench (NN).
2
A
AA
FF
AA
FF
A
B2
B2
AA
FF
II
AA
II
FF
G1 N1 B1
B1 B2
B2 B1
G1 N1 B1
A
H
H
H
Hardware Used
M6 × 15 mm Bolt
X16
X16
Washer
AA
FF
X1
Wrench
NN
3. Insert the two Crossbeam Connector (G1) into
the Crossbeam Right (B2) and connect them with
Bolt (AA) and Flat
Washer
(FF). Insert the Top
Crossbeam Shield (N1) into the Crossbeam Right
(B2). Connect the Crossbeam Left (B1) / Top
Crossbeam Shield (N1) to the Crossbeam
Connector (G1) with Bolt (AA) and Flat
Washer
(FF). Tighten together with the Wrench (NN). Place
Cap (II) on the Bolt (AA).
Hardware Used
M6 × 15 mm Bolt
X8
X8
X8
Cap
Washer
AA
FF
II
X1
Wrench
NN
AA
FF
II
3
AA
II
FF
B2 B1
N1
To Next Page
Loading...